Magnadyne LINEAR SERIES RV4000 Manual de usuario

Busca en linea o descarga Manual de usuario para Receptores y amplificadores Magnadyne LINEAR SERIES RV4000. Magnadyne LINEAR SERIES RV4000 User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir

Indice de contenidos

Pagina 1 - Operation

Operationand InstallationManual®RV4000AM / FM Stereo Multi-Media ReceiverEQ1AS/PS2SLP3ALM4DISP5DIM6PUSH3-Beam Laser PickupA BAUXAM/FMDISCSPEAKERSPKFM

Pagina 2 - Introduction

10 Radio OperationsSelecting the Play Source:Press the AM/FM button and “rAdIO” appears in the display. After a brief moment either AM or FM will appe

Pagina 3 - 3-Beam Laser Pickup

11 Disc WarningsDVD12cm disc(Single-sided disc only)CD12cm discMP312cm discLabel side upDo not touchthe undersideof the discDo not bendWipe the disc f

Pagina 4

12 Music Disc OperationGeneral Operations:1. Push the door access the disc player.2. Insert the disc onto the hub with the label facing forward. Use

Pagina 5 - Sound Controls

13 Music Disc Operation (Continued)Removing the Disc:1. Push the door to access the disc player. Wait until the disc stops spinning before opening up

Pagina 6

14 MP3 Disc OperationGeneral Operations:1. Push the door access the disc player.2. Insert the disc onto the hub with the label facing forward. Use yo

Pagina 7 - Setting the Clock

15 MP3 Disc Operation (Continued)Removing the Disc:1. Push the door to access the disc player. Wait until the disc stops spinning before opening up th

Pagina 8 - Sleep Timer Operation

16 Audio InputSelecting the Audio Input Source:Note 1: The RV4000 does not control the device, it just allows the audio to be played through the syste

Pagina 9 - Alarm Operation

17The LCD display may fail to function normally due to the vehicle’s battery condition, and could require resetting the radio microprocessor if:• The

Pagina 10 - Radio Operations

18 Installation945/8” 61/4” Chassis Opening Structural Stud Wall Panel Caution: Do not install radio without rear cover installed: No user-serviceabl

Pagina 11 - Radio Operation (Continued)

19 Speaker Connections_ + Gray Wire White/Black Wire (Common -)_ + Gray/Black Wire RightSpeaker BLeftSpeaker B_ + Brown/Black Wire White Wire (Common

Pagina 12 - Music Disc Operation

Please take the time to read all of the information in this manual. Familiarity with operation and installation procedures will help you obtain the be

Pagina 13 - (Continued)

20 Wiring and Auxiliary ConnectionsRed Wire (+) to 12 Volt DC PowerBlack Wire GroundMusic Disc Player(Optional)Audio InAudio Out10A FuseExternal Autom

Pagina 14 - MP3 Disc Operation

21Outdoor Antenna Grounding: If an outside antenna is connected to the receiver, be sure the antenna system is grounded, so as to provide some protect

Pagina 15

22 WarrantyONE (1) YEAR LIMITED WARRANTYMagnadyne Corporation or its authorized agents will within one year from the date of sale to you, repair, repl

Pagina 17 - Additional Feature

© Copyright 2011 Magnadyne CorporationRV4000-UMRev. A 5-19-11

Pagina 18 - Installation

Button Locations and Functions3 1. Power On/Off: Press to turn the unit on or off. 2. Disc Door: To play a disc, insert the disc with label facin

Pagina 19 - Speaker Connections

4 Button Locations and Functions (Continued)16. Dimmer Button (DIM): Press to dim the lighting in the display area. Sequential presses will select dif

Pagina 20

5 General OperationsSelecting a Play Source:To select a play source, press one of the follow-ing mode buttons: AUX (Auxiliary Audio Input), AM/F

Pagina 21 - Safety Instructions

6 Sound ControlsBass:Select the Bass mode by pressing the VOLUME knob. Increase the Bass by rotating the VOLUME knob clockwise. Decrease the Bass by r

Pagina 22 - ONE (1) YEAR LIMITED WARRANTY

7 Sound Controls (Continued)Mute:Press the button to mute the volume level. Press the button again to restore the volume. Speaker Selecti

Pagina 23

8 Sleep Timer OperationSetting the Sleep Timer:1. Press the SLP button until the “SLP 10” appears in the display.2. Keep pressing the SLP button again

Pagina 24 - Rev. A 5-19-11

9 Alarm OperationSetting the Alarm Timer:1. Press the ALM button and the clock will appear in the display with the hour number flashing.2. Rotate the

Comentarios a estos manuales

Sin comentarios